สร้างความแตกต่างให้กับลูกค้าของเรา
02-136-1770

ธันเดอร์เลเซอร์ ประเทศไทย

troubleshooting troubleshooting
Location:Home>troubleshooting > Why the laser head hitting the boundary or the limit switch
Image-1

How to adjust the laser beam path


Image-1

How to install new laser tube


Why the laser head hitting the boundary or the limit switch

Release Time:2016/05/19 troubleshooting Browsing Times:1946

There are three possibilities

A. Wrong pulse setting

If your laser cutter has a wrong pulse setting, the laser head might keep moving even it reaches the edge and hits the boundary.

If that is the problem, you need to reset the pulse parameter to fix it.

Please refer to the following link to reset the pulse parameter.

https://www.thunderlaserthai.com/troubleshooting/laser-cutter-has-a-wrong-cuttingengraving-size.html

B. The limit switch does not match the controller

Most laser cutter controller only works with the NPN-NO type switch. If you use other types, it will leads to the laser head hitting the edge. Please choose the correct limit switch to fix this problem.

C. Wrong wiring

If wiring of limit switch is wrong, it also leads to the laser head moving over edge.

Please refer to the following pictures to correct the wirings to solve the problem.

some trouble of laser cutter

wiring diagram for mechanical switch

some trouble of laser cutter

diagram for proximity switch

Please notice: set the limit polarity to “negative” in the factory parameters

If you need other helps, please refer to the others trouble shooting or contact with us by sending email to us “tech@thunderlaser.com”