สร้างความแตกต่างให้กับลูกค้าของเรา
02-136-1770

ธันเดอร์เลเซอร์ ประเทศไทย

laser cutter machine machine

Location:Home>troubleshooting>laser cutter machine
Image-1

Thunder Laser Video


How to choose a reliable laser cutter

WATCH NOW
▷ How to choose a reliable laser cutter
laser parametes

Thunder Laser Video


Laser Samples Parameters

WATCH NOW
▷ Laser Samples Parameters

  • Why the red dot pointer not being able to come out from the laser head.

    Why the red dot pointer not being able to come out from the laser head.

    Release Time:2019/06/01Browsing Times:1283

    Here are the reasons: ● The red dot pointer is off Locate on the Red Dot Pointer Mount in the rear of the machine, and check if the Red Dot Pointer is off, like below. If yes, ple...

  • Chiller alarms unusually

    Chiller alarms unusually

    Release Time:2019/06/01Browsing Times:918

    Chiller lcd panel is showing normal, but the red light on and buzzer beeping. Here are the reasons: ● Water is not enough Please check the water level of chiller, like below: Kee...

  • Air pump won’t work or no air  assist when job starts

    Air pump won’t work or no air assist when job starts

    Release Time:2019/06/01Browsing Times:934

    Here are the reasons: ● Air compressor break down How to check if air compressor break down, there’s a common way to connect it to the power directly using the power cable of chiller, th...

  • Exhaust fan cannot extract smoke  or dust

    Exhaust fan cannot extract smoke or dust

    Release Time:2019/06/01Browsing Times:888

    Here are the reasons: ● Exhaust fan break down How to check if exhaust fan break down, there’s a common way to connect it to the power directly using the power cable of chiller, then che...

  • Cutting problem– Some point of the same piece  of materials cannot be cut through

    Cutting problem– Some point of the same piece of materials cannot be cut through

    Release Time:2019/06/01Browsing Times:889

    Here are the reasons: ● The needed focus is lost The bending of the material or the uneven working table can result in different focal lengths, especially for the large cutting graphic. ...

  • Engraving problem—the engraving quality is very poor

    Engraving problem—the engraving quality is very poor

    Release Time:2019/06/01Browsing Times:682

    Here are the reasons: ● The needed focus is lost The bending of the material or the uneven working table can result in different focal lengths, especially for the large engraving graphic....

  • The laser tube won’t fire the beam

    The laser tube won’t fire the beam

    Release Time:2019/06/01Browsing Times:833

    Here are the reasons: ● The laser switch is off Please make sure laser switch is on, then open lower left hand door panel (or back side door panel), check if the laser power supply is showing ...

  • X-axis not moving at all

    X-axis not moving at all

    Release Time:2018/11/17Browsing Times:792

    Here are the reasons: ● X-axis limit switch problem Locate on the left side of x-axis, please check if the wiring and roller lever of switch are well or not, like below. If they both se...